Simpson CD25114RC 148221 Rod Coupler Crimp Anchor 8211 Zinc Pkg 100

The Simpson Strong-Tie Crimp Drive anchor is an easy-to-install expansion anchor for use in concrete and grout-filled block. The pre-formed curvature along the shaft creates an expansion mechanism that secures the anchor in place and eliminates the need for a secondary tightening procedure. The Rod Coupler head is designed for 1/4\” threaded rod, which is commonly used for hanging sprinkler pipes and suspended ceiling panels. Installation: Warning: Industry studies show that hardened fasteners can experience performance problems in wet or corrosive environments. Accordingly, with the exception of the duplex anchor, use these products in dry, interior and non-corrosive environments only. Drill a hole using the specified diameter carbide bit into the base material to a depth of at least 1/2\” deeper than the required embedment. Blow the hole clean of dust and debris using compressed air. Overhead application need not be blown clean. Where a fixture is used, drive the anchor through the fixture into the hole until the head sits flush against the fixture. Be sure the anchor is driven to the required embedment depth. The rod coupler and tie-wire models should be driven in until the head is seated against the surface of the base material. California Residents: WARNING